來源：http://www.whidbeyartsource.com 發布時間：2022-07-09 18:00:10
Sandblasting angular aluminum can be used as profiles or machined parts. No matter which way of use, it can only be installed after processing. The processing method of sandblasting angular aluminum is the same as that of commonly used aluminum profiles, which can be cut, punched, tapped, or even carved and customized. Now let's give you a specific explanation.
Sandblasting angular aluminum machined parts
One sandblasting angle aluminum profile is 6 meters long, but it is rarely used as a whole, and it is cut and processed according to requirements. At this time, the cutting technology will be used. The size cutting will be carried out according to the customer's use requirements, and the cutting type can also meet the cutting requirements of different angles.
However, when sandblasting angular aluminum is processed into angular parts, tapping technology will be used to drill holes and tap on the processed angular parts, and work on the connection between various profiles or profiles and plates. Just like the worktable in the figure below, tapping is used to fix the worktable top and the profile. The other side of the sand blasting angular aluminum workpiece is directly tapped and tightened with flat machine bolts.
Sand blasting angular aluminum cutting
Through holes can also be drilled on the sandblasting angle aluminum profile. Take the workbench as an example to introduce to you. There are no holes on the sandblasting angle aluminum profile. Punch through holes at the positions where accessories need to be used, so as to facilitate the bolts to directly pass through and connect with the profile.
Sandblasting angle aluminum belongs to the aluminum profile series, but it can be processed into angle brackets as accessories. The length of one piece of sand blasting angle aluminum is 6 meters, which can be customized according to customer needs. So what should we pay attention to in the processing process? The following editor will explain it to you in detail.
In addition, the aluminum plate manufacturer reminds you that in fact, there are many types of sandblasting angular aluminum, and its material is 6063-T5. In the processing process, you also need to select the corresponding sandblasting angular aluminum processing angular parts according to the corresponding profiles. There are two points that should be paid attention to in general sand blasting angular aluminum processing:
First, when cutting sand blasting angular aluminum, it should be cut according to the size required by the customer. The cutting end face should be flush, and there should be no aluminum chipping on the end face. This attention is related to the processing equipment used, as well as the quality of the cutting tools, which can be understood with the merchants when purchasing.
The second is to punch holes in the cut sandblasting angle aluminum. The corresponding sandblasting angle aluminum should be selected for the selected series of profiles. Position and punch holes on the cut accessories, and the position of the holes cannot be offset.
The above is all about the problems and precautions introduced to you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website http://www.whidbeyartsource.com , our staff will contact you in time.